1. Separation process requirements: Warm water with a water temperature of 40-50 degrees is sufficient. Add 1% -3% sodium hydroxide before separation, which can improve the separation effect and efficiency. 2. Before separation, install the equipment according to the instructions and check the separator for abnormalities, and turn on the power. First add warm water and chemicals to the separator, add the water level to 2/3 of the volume of the tank, start the motor, input the raw materials after the water flow rotates, and determine the separation time according to the difficulty of separating the raw materials during the first operation of the equipment. Generally, the raw materials can be completely separated after 30-40 minutes, and the easy separation can also be completely separated in 20 minutes. After the separation of the paper-plastic separator, take a sample to check the separation effect. If the separation effect is not ideal, you can extend the separation time to achieve a satisfactory separation effect. 3. There is a pneumatic valve (circular) under the paper-plastic separator for discharging pulp and water. When installing, you need to connect the same size pipe to the outside of the separator cylinder and install the pneumatic valve. There is a pneumatic discharge valve (square) on the upper part of the separator. According to the site requirements, the cylinder of the pneumatic valve is installed on the left or right side of the separator. At the same time, the two corners of the square outlet are cut off by gas welding, and the pneumatic valve is installed. It is necessary to use a rubber sheet as an intermediate cushion to prevent water from flowing out. 4. The separated plastic is discharged through the plastic discharge port, and then enters the cleaning tank 1 and the cleaning tank 2 for manual washing. The washed water contains a small amount of pulp and needs to enter the No. 1 tank for processing to separate the pulp and water. Pulp and water first enter the No. 1 tank through the pulp discharge port, and then the pulp pump is used to transport the pulp to the inclined screen, and the inclined screen is used to separate the pulp fiber and water. The separated clean water enters the No. 2 collection tank for cleaning the pool and paper Plastic separator to recycle water. "Puzzle 3D Eraser Bulk,Puzzle 3D Eraser,Building Blocks Eraser,Toppers Cute Erasers " Yiwu Shengshang Stationery Co., Ltd. , https://www.ss-stationery.com