The plate processor must be installed on a flat, clean indoor floor. For the convenience of operation and maintenance, the space left and right of the machine must be no less than 750mm wide. There must be sufficient entry and exit space before and after the machine. This article will introduce you to the used ps version. When the CTP processor is enabled, first turn on the air switch, turn on the pump power, turn on the CTP power, and turn off the power in the reverse order. It should be noted that it is strictly forbidden to open any door and cover of the CTP platen during the process of switching on the machine, which may easily lead to personal accidents. After the CTP processor is turned on, please warm up for half an hour before running, otherwise it will reduce the quality of the publication and damage the machine. Another point is that the roller, the cleaning roller, and the outer cover filter must be cleaned once a month, and the optical filter is cleaned once every 3 months. Nowadays, the most used thermal type ctp plate-making machine in commercial and packaging printing is also used in newspapers. It is characterized by high precision and mature technology. The system requires a dedicated thermal CTP version, and there are a variety of domestic and international brands available on the market. The plate machine uses a low concentration of glue in the gluing process, and oxidation of the non-image part will cause the plate to become dirty. The solution to this kind of problem is: the surface should be fully washed after being dirty, the glue concentration should be increased when the glue is applied, the glue should be evenly distributed; the cover should be tightly closed after the use of the dirty note; the plate after the glue is applied, the length of the plate is dry Then print again. Whether the parts of the platen machine are damaged due to transportation, if any, immediately make a corresponding record and take pictures of the damaged part, and contact the carrier or supplier in time. A 4 minute tap water pipe should be connected to the equipment room. The height of the machine room drain should not be 150mm higher than the floor space of the platen machine. In order to facilitate the cleaning of the roller shaft and other parts, a properly sized pool should be provided in the equipment room. Article source address: http:// Car Seat for Baby, new born baby car seat, infant car seat, baby car safety seats, car seat for little baby NINGBO BABY FIRST BABY PRODUCTS CO.,LTD. , https://www.maxinfglobal.com